Control system
It consists of computer panel, computer chip, program software, various sensors, etc.
Gun body
The inner surface is specially treated to prevent corrosion. A door is installed at the end of the barrel. Insert a soap trough on top. The heater and drain valve are installed on the lower tank. The barrel is fixed to the base of the machine through a shock absorber. Roller
Small holes and barrel-like tendons on the drum wall allow the fabric to continuously roll in the drum. The front end of the drum is a clothes door, which is installed on the barrel through a shaft seat as much as possible.
Transmission mechanism
The transmission mechanism consists of a frequency converter, a frequency conversion motor, a pulley, a V-belt and a bearing seat. This enables the machine to achieve washing, uniform distribution and dewatering at the required speed.
Suspension mechanism
The shock-absorbing mechanism is fixed on the machine base through compression springs, tie rods, hooks and supports. The main components, such as the barrel, cylinder and transmission mechanism, are suspended from the support of the shock absorbing mechanism by a pull rod. The machine is produced during high-speed dehydration. The spring damped the vibration. In addition, the shock absorbers are reduced on the left and right sides of the machine to reduce the swing amplitude during vibration.
Door
For loading and unloading clothes. The door is made of stainless steel. During work, insert the rubber seal into the door and seal with a barrel. The door lock is used to open or close the door. Switches are alternately connected in the door lock to ensure that the machine is running. Do not open to ensure operator safety.
Inlet diameter
Coaxial solenoid valve on the intake pipe.
Drain valve
The opening and closing of the drain valve is controlled by a solenoid valve.
Heater
This machine has two heating methods, one is steam heating and the other is electric heating. Steam heating is controlled by a pneumatic valve, and electric heating is equipped with three sets of electric heating tubes.